Yamaha HTR-5140RDS - Manual (Page 48)

48
C.DELAY [Adjusting the delay of
center sounds (dialog, etc.)]
Control range: 0 ms to 5 ms (in 1 ms steps)
Preset value: 0 ms
* This adjustment is effective only when Dolby Digital is
decoded and the signals of the selected source encoded with
Dolby Digital contain center-channel signals.
This adjusts the delay between the main sound (on the main
channels) and dialog, etc. (on the center channel).
The larger the value, the later the dialog, etc. is generated.
This is for making sounds from the left main, center and right
main speakers reach your listening position at the same time.
This is achieved by delaying the sound from the center speaker
if the distance from the center speaker to your listening position
is shorter than the distance from the left or right main speaker
to your listening position.
GUARD
Choices: ON/OFF
Preset position: OFF
If you wish to prevent accidental alterations to SET MENU and
other adjustments on this unit, select ON. The following
functions on this unit can be locked by this operation:
• Functions in the SET MENU mode
• Functions in the TIME/LEVEL mode
• Functions when using TEST
INPUT (Selecting the initial input mode of
the sources connected to the TV/DBS
input terminals)
Choices: AUTO/LAST
Preset position: AUTO
You can designate the input mode that is automatically selected
when the power for this unit is switched on for only the sources
connected to the TV/DBS input terminals of this unit.
AUTO: In this position, the AUTO input mode is always
selected when the power for this unit is switched on.
LAST: In this position, the input mode you selected last time
is memorized and will not be changed when the
power is switched on again.
* See page 28 for details on switching the input mode.
Adjusting method
Adjustments should be made while watching the information on
this unit’s display.
When adjusting with the remote control transmitter, press
AMP on the component selector.
Press SET MENU once or more so that the function which you
want to change appears on the display.
Front panel Remote control
or
Press + or – to select any desired setting or to edit parameters
of the function.
Front panel Remote control
or
Repeat these steps to change or adjust the settings of any
other function.
Memory back-up
The memory back-up circuit prevents the stored data from
being lost when this unit is set in the standby mode. If,
however, the power plug is disconnected from the AC outlet or
the power is cut due to temporary power failure for more than
one week, the settings of the SET MENU mode will
automatically return to the factory settings. If so, they can be
re-set by simply following the procedure above.
01RX-V495RDS-5 6/22/99, 12:29 PM 48