Yamaha RX-V496RDS - Manual (Page 8)

6
Display
8 MEMORY indicator
This flashes for about five seconds after pressing
MEMORY. During this period, the displayed station can be
stored in the memory.
9 RDS mode indicators
The name(s) of the RDS data offered by the currently
received RDS station light(s) up. Illumination of the red
indicator next to the RDS data name shows that the
corresponding RDS mode is now selected.
0
AUTO indicator
This lights up when the unit is in the automatic tuning
mode.
q PTY HOLD indicator
This lights up while searching for stations in the PTY SEEK
mode.
w EON indicator
This lights up when an RDS station that offers the EON data
service is being received.
e
Program type name indicators
The name of the selected program type lights up when the
“EON” indicator lights up.
r
STEREO indicator
This lights up when an FM stereo broadcast with sufficient
signal strength is being received.
t
Signal-level indicator
This indicates the signal level of the station being received.
If multipath interference is detected, the indication
decreases.
y
SLEEP indicator
This lights up while the built-in SLEEP timer is on.
CONTROLS AND FUNCTIONS
1
t indicator
The “t” indicator lights up when the built-in DTS
decoder is turned on.
2 DSP program indicators
The name of the selected DSP program lights up in the
following cases:
•
When the tuner is selected as the input source.
• When DSP program No. 2, 3 or the subprogram
“ENHANCED” of No.1 is selected.
3
Multi-information display
This display shows various information: for example the
name of the selected DSP program and the various settings
during adjustment with the SET MENU. The current station
frequency and band (FM or AM) also appear when the tuner
is selected as the input source.
4 Input source indicators
One of the arrows for these indicators lights up depending
on which source is selected.
5
TAPE/MD MONITOR indicator
This lights up when the tape deck or MD recorder, etc. is
selected as the input source by pressing TAPE/MD MON /
EXT. DECODER (or TAPE/MD).
6
g and o indicators
“ g ” lights up when the built-in Dolby Digital
decoder is on and the signals of the selected source encoded
with Dolby Digital are not in 2-channel. “ o ”
lights up when the built-in Dolby Pro Logic decoder is on.
7
x indicator
“ x ” lights up when the built-in digital sound
field processor is on.
0102V496RDS01-07_EN 1/12/0, 10:26 AM 6