Yamaha RX-V757 - Manual (Page 82)

80
EDITING SOUND FIELD PARAMETERS
4 Press u / d to select
the parameters.
5 Press j / i to change
the parameter value.
When you set a parameter
to a value other than the
factory-set value, an
asterisk mark (*) appears
by the parameter name on
the on-screen display.
y
If you press and hold to change the parameter value, the
front panel display automatically stops at the factory preset
parameter momently.
6 Repeat steps 3 through 5 as necessary to
change other program parameters.
You cannot change parameter values when “MEMORY GUARD”
is set to ON. If you want to change the parameter values, set
“MEMORY GUARD” to OFF (see page 64).
■ Resetting parameters to the factory
presets
To reset all parameters
Use PARAM. INI (see page 65).
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
CH CH
TV VOL
TV MUTE
ENTER
TV VOL
PRESET
PRESET
CH CH
TV VOL
TV MUTE ENTER
TV VOL
PRESET
PRESET