Operation – Zenoah BC2601DL User Manual

Page 11

■

STARTING ENGINE

1. Rest the unit on a flat, firm place. Keep the

cutting head off the ground and clear of
surrounding objects as it will start rotating
upon starting of the engine.

2. Pump the primer until fuel flows out in the

clear tube.

3. Move the choke lever upward to close the

choke.

4. Shift the ignition switch to the START

position.

Operation

5. While pulling the throttle lever with the little

finger of your left hand, pull the starter
rope.

• Avoid pulling the rope to its end or returning

it by releasing the knob. Such actions can
cause starter failures.

6.When the engine has started, move the

choke lever gradually downward to open
the choke.

7.Allow the engine to warm up for a half

minute before starting operation.

1.When restarting the engine immediately

after stopping it, leave the choke open.

2.Overchoking can make the engine hard to

start due to excess fuel. When the engine
failed to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.

NOTE

❲

❳