Yamaha DSP-AX620 EN - Manual (Page 20)

18
CONNECTIONS
Connecting an External Amplifier
(Europe and U.K. models only)
If you want to increase the power output to the speakers,
or want to use another amplifier, connect an external
amplifier to the OUTPUT jacks as follows.
Note
• When RCA pin plugs are connected to the OUTPUT jacks for
output to an external amplifier, do not use the corresponding
SPEAKERS terminals.
1
MAIN jacks
Main channel line output jacks.
Note
• The signals output through these jacks are affected by the
BASS, TREBLE and BASS EXTENSION settings.
2
REAR (SURROUND) jacks
Rear channel line output jacks.
3 CENTER jacks
Center channel line output jacks.
OUTPUT
MAIN
R L
R L
REAR
(SURROUND)
CENTER
1
2
3
Connecting an External Decoder
This unit is equipped with 6 additional input jacks (left
and right MAIN, CENTER, left and right SURROUND
and SUBWOOFER) for discrete multi-channel input from
an external decoder, sound processor or pre-amplifier.
Connect the output jacks on your external decoder to the
6CH INPUT jacks. Be sure to match the left and right
outputs to the left and right input jacks for the main and
surround channels.
Notes
• When you select 6CH INPUT as the input source, this unit
automatically turns off the digital sound field processor, and
you cannot listen to DSP programs.
• When you select 6CH INPUT as the input source, changing
items 1A to 1E on the SET MENU is not affected.
0103AX620(GB)_11-18_EN 1/23/1, 9:26 AM 18