Yamaha F25 - Manual (Page 33)

Operation
28
EMU27964
Procedure for tilting up (manual tilt
models)
1. Place the gear shift lever in neutral (if
equipped) and face the outboard motor
forward.
2. On full-pivot system models, tighten the
steering friction adjuster by turning it
clockwise to prevent the motor from turn-
ing freely.
3. Tighten the air vent screw. On models
equipped with a fuel joint, disconnect the
fuel line from the outboard motor.
4. Close the fuel cock.
5. Tilt support bar equipped models: Hold
the rear of the top cowling or the rear han-
dle (if equipped) with one hand and tilt the
outboard motor up fully until the tilt sup-
port bar automatically locks.
6. Tilt support knob equipped models: Hold
the rear of the top cowling with one hand,
fully tilt the outboard motor up, and push
the tilt support knob into the clamp brack-
et.
7. Tilt support lever equipped models: Hold
the rear handle and tilt the engine up fully
until the tilt support lever automatically
locks.
NOTE:
Tilt support lever/bar equipped models: If the
motor is not facing forward, the tilt support le-
ver/bar cannot automatically turn to the
U69M15E0.book Page 28 Wednesday, April 5, 2006 4:48 PM