Yamaha CDX-993 - Manual (Page 5)

5
To connect this unit to your amplifier, choose one of the following procedures:
1 When the LINE OUT (analog) terminals of
this unit are used
• Connect to either the VARIABLE terminals or the FIXED
terminals. (As a general rule, connect to the FIXED
terminals.)
VARIABLE:The output level of these terminals can be
adjusted by using the OUTPUT LEVEL
button on the remote control transmitter (or
OUTPUT LEVEL control on the front panel).
FIXED: The output level of these terminals is not
variable.
• Be sure that the left (“L”) and right (“R”) LINE OUT
terminals are connected to the corresponding (left and
right) terminals of the amplifier or other component.
• Connect the “LINE OUT” terminals to the “CD” (or “AUX”)
terminals of the amplifier. If the amplifier does not have
such terminals, use the “TAPE PB” terminals. For
additional details concerning these connections, refer to
the operation instructions for the amplifier being used.
• The LINE OUT terminals of this unit are numbered 1 .
When connecting this unit with a YAMAHA amplifier or
receiver whose terminals on the rear panel are
numbered as
1 , 2 , 3 , etc., connect the LINE OUT
terminals of this unit to the input terminals numbered 1
on the rear of the amplifier or receiver.
2 When the DIGITAL OUT (OPTICAL)
terminal(s) of this unit is used
This unit has two DIGITAL OUT (OPTICAL) terminals on
the front panel and the rear panel.
• Before using the terminal on the rear panel, remove the
terminal’s cover.
• Make the connection from the terminal(s) to the optical
input terminal(s) of an amplifier and/or other digital audio
components by using a commercially available optical
fiber cable(s).
* Use an optical fiber cable that conforms to EIAJ
standards. Other cables might not function correctly.
• Be sure to replace the terminal’s cover when the terminal
on the rear panel is not being used, in order to protect
from dust.
• The terminal(s) can also be connected to the optical
input terminal of a DAT (Digital Audio Tape) deck or MD
(Mini Disc) deck etc. to record a CD directly.
• The output level of these terminals is not variable.
3 When the DIGITAL OUT (COAXIAL) terminal
of this unit is used
• Make the connection from this terminal to the digital
input terminal of an amplifier by using a connection cord.
• The output level of this terminal is not variable.