Yamaha E580 - Manual (Page 16)

CONNECTING TO VIDEO SIGNAL JACKS
If your integrated amplifier or similar component is equipped with
a video output jack, connect it to this unit’s VIDEO IN jack, and
connect this unit’s VIDEO OUT jack to the video input of your
monitor.
* If your integrated amplifier or similar component is not equipped
with any video output jack, connect the video output jack of your
video cassette recorder or another video source to this unit’s
VIDEO IN jack directly.
If your integrated amplifier, video cassette recorder, etc. and your
monitor are equipped with “S” (high-resolution) video terminals,
connect the “S” video output from your integrated amplifier or video
source to this unit’s S VIDEO IN jack, and connect this unit’s S
VIDEO OUT jack to the “S” video input of your monitor.
NOTE: If video signals are sent to both S VIDEO input and VIDEO
input jacks, the signals will be sent to their respective output jacks
independently.
NOTE: If your unit is the General Model, be sure the NTSC/PAL
switch has been correctly set to the standard that your video
equipment employs. U.S.A. and Canada models have no switch and
use the NTSC standard, while other models without a switch use the
PAL standard.
Notes about the Video superimpose
● If you watch a video source which is connected to both S VIDEO
and VIDEO input jacks of this unit, signals of screen display
information are output from only the S VIDEO OUT jack.
● When no video signal is input to either S VIDEO IN and VIDEO IN
jacks of this unit, signals of screen display information are output
from both S VIDEO OUT and VIDEO OUT jacks with a color
background.
* For the General Model, if the NTSC/PAL switch on the rear panel
is set to “PAL”, nothing will be output from either S VIDEO OUT or
VIDEO OUT jack in this case.
14
Integrated Amplifier etc.
Monitor TV
VIDEO
OUT S VIDEO
OUT
VIDEO
IN S VIDEO
IN