Zanussi TCE 7124 W - Manual (Page 5)

5
The Control Panel
1 Programme Chart
This will help you to select the correct programme
for drying.
2 Mains-On Light
Comes on when the appliance is switched on
(ON/OFF button pressed down) and goes out when
this button is released.
3 ON/OFF Button
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
4 Low Temperature
Button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
This option can also be used for time controlled
drying.
The dryer heats at 1400 W instead of 2200 W.
If the button is not pressed, drying is performed at
full power (2200 W).
5 Buzzer OFF Button
A buzzer sounds by depressing the push buttons
during the anti-creasing phase, at the end of
programme and when the water reservoir is full.
Press this button when selecting the programme if
you wish to switch the buzzer off during the anti-
creasing phase. The corresponding light illuminates.
6 Start button
Press this button for about 2 seconds to start the dryer
after having selected the programme.
If the door of the appliance or the small door
covering the condenser and the water reservoir is
opened while the programme is running, this button
must be pressed again after closing the door in
order to restart the programme from the point at
which it was interrupted.
This button must be also depressed after a power
failure and after having re-inserted the water
reservoir, if it has been emptied in the middle of a
programme.
In both cases light or (depending on the
phase in progress) flashes to remind you that the start
button needs to be pressed again.
7 Programme Phase
Indicator Lights
These lights indicate the various phases of the
programme as they are being performed.
“Drying” light
This light indicates that the appliance is in the drying
phase.
“Cooling” light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
If light
or is flashing, this means that the Start
button needs to be pressed again for the programme
to resume.
“End of programme” light
This light flashes at the end of the cooling phase and
during the anti-creasing phase.
“Water reservoir full” light
This light flashes when the reservoir is full.
ON/OFF LOW TEMP. BUZZER OFF
START
L
TIMED
PROGRAMME
DRY
FRESH
6
X TRA C APACITY
CONDENSER DRYER
E L E C T R O N I C S E N S O R
1 2 3 4 5 6 7 8
TCE 7124 W
A U T O R E V E R S E
A B C D E F G H J K
WRING
DRY
SLIGHTLY
DAMP
STORE
DRY
READY
TO WEAR
EXTRA
DRY
IRON
DRY
0 A
B
C
D
E
F
G H J
K
90’
60’
30
’
L
EXTRA
DRY
SYNTHETICS
BABY
DRY
STORE
DRY
IRON
DRY
COTTON
125992080.qxd 4/29/03 10:51 AM Pagina 5 (Nero/Process Black pellicola)