beautypg.com

Digital sound field processor (dsp) effect, E-20, Selecting a dsp program – Yamaha DSP-E800 User Manual

Page 22

background image

E-20

DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT

Selecting a DSP Program

You can enhance your listening experience by selecting a
DSP program. Refer to pages 22 to 24 for details about each
program.

1

Make sure that the effect speakers (center and
rear) and subwoofer are turned on.

2

Press PROGRAM

l

or

h

repeatedly (or one of

the PROGRAM selector buttons) to select the
desired program.

The name of the selected program appears on the
display.

y

If desired, adjust the delay time and the sound output level of each
speaker. (Refer to pages 29 and 30 for details.)

Notes

• You can select a DSP program for each of the input sources. Once

you select a program, it is linked with the input source selected at
that time. So, when you select the input source next time, the
same program is automatically selected.

• When a monaural source is being played with PRO LOGIC/

Normal or PRO LOGIC/ENHANCED, no sound will be heard
from the main speakers and the rear speakers. Sound can only be
heard from the center speaker. However, if “CENTER SP” on the
SET MENU is set to the NONE position, the center channel
sound is output from the main speakers.

• When a source connected to the 6CH INPUT terminals of this

unit is selected, the digital sound field processor cannot be used.

• When high-rate 96-kHz sampling 24-bit digital signals are input

to this unit, no DSP program can be selected and the sound is only
output from right and left main speakers as a normal 2-channel
stereo sound.

PROGRAM

PRO LOGIC

DSP

MOVIE THEATER 2

DVD/LD

D–TV

VCR

TUNER
CD
CBL/SAT

PROGRAM

/DTS

SUR.

2

1

4

MOVIE

THTR 1

3

MOVIE

THTR 2

MONO MOVIE

7

ROCK

5

TV SPORTS

8

HALL

6

DISCO

Canceling the Sound Effect (turning
off the effect speakers)

Press EFFECT to cancel the sound effect and
monitor only the main sound.

Press EFFECT again to turn the sound effect back on.

Notes

• If you turn off the sound effect when Dolby Digital or DTS is

decoding, the sounds of the center and rear channels are mixed
and output from the main speakers.

• If you turn off the sound effect when Dolby Digital or DTS is

decoding, it may happen that the sound is output faintly or not
output normally, depending on the source. In this case, turn sound
effect back on.

EFFECT

Front panel

EFFECT

Remote control

STANDBY/ON

INPUT MODE

INPUT SELECTOR

VOLUME

16

20

28

40

60

00

0

2

4

8

12

–dB

PROGRAM

SET MENU

EFFECT

TAPE/MD MON

/6CH INPUT

NEXT

+

NATURAL SOUND AV PROCESSOR/AMPLIFIER DSP–E800

CINEMA DSP

DOLBY

D I G I T A L

D I G I T A L

S U R R O U N D

2

POWER

PROGRAM

/DTS

SUR.

2

1

4

MOVIE

THTR 1

3

MOVIE

THTR 2

MONO MOVIE

7

ROCK

TEST

TIME/LEVEL

6CH INPUT

SET MENU

5

TV SPORTS

8

HALL

6

DISCO

EFFECT

DSP

CD

TUNER TAPE/MD

2

Front panel

Remote control

or

DSP program name

or

104.E800_16-20(Eng)

5/18/0, 1:37 PM

20