Yamaha DSP-E800 - Manual (Page 15)

E-13
English
B
ASIC OPERA
TION
AD
V
ANCED OPERA
TION
APPENDIX
INTR
ODUCTION
PREP
ARA
TION
SET BEFORE POWER ON
REAR
CENTER : 4 Ω MIN./SPEAKER
: 4 Ω MIN./SPEAKER
REAR
CENTER : 8 Ω MIN./SPEAKER
: 8 Ω MIN./SPEAKER
AC OUTLET
SWITCHED
100W MAX.
IMPEDANCE SELECTOR
Connecting the Power Supply Cords
After completing all connections, connect the AC power
cord to an AC power outlet. Disconnect the AC power cord
if you will not use this unit for a long period of time.
■ AC OUTLET (SWITCHED)
U.K. and Europe models .................................... 1 OUTLET
Use this outlet to connect the power cords from your
components to this unit. The power to the AC OUTLET is
controlled by this unit’s STANDBY/ON (or POWER). This
outlet will supply power to any connected component
whenever this unit is turned on. The maximum power (total
power consumption of components) that can be connected
to the AC OUTLET is 100 W.
IMPEDANCE SELECTOR Switch
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit may be
damaged.
If this unit fails to turn on when STANDBY/ON (POWER) is pressed, the IMPEDANCE SELECTOR switch may not be
fully slide to either position. If so, slide the switch to either position fully when this unit is in the standby mode.
Select the right or left position according to the impedance of speakers in your system. Be sure to move this switch only
when this unit is in the standby mode.
(Europe model)
SET BEFORE POWER ON
REAR
CENTER : 4 Ω MIN./SPEAKER
: 4 Ω MIN./SPEAKER
REAR
CENTER : 8 Ω MIN./SPEAKER
: 8 Ω MIN./SPEAKER
AC OUTLET
SWITCHED
100W MAX.
IMPEDANCE SELECTOR
SWITCHED
(Europe model)
To AC outlet
IMPEDANCE
SELECTOR
CONNECTIONS
Switch potision
Left
Right
Speakers Impedance level
Rear
Center
Rear
The impedance of each speaker must be
4
Ω
or higher.
The impedance must be 4
Ω
or higher.
The impedance of each speaker must be
8
Ω
or higher.
The impedance must be 8
Ω
or higher. Center
103.E800_07-15(Eng) 5/18/0, 1:37 PM 13