Yamaha RX-V495RDS - Manual (Page 8)

8
q
INPUT MODE
This button switches the DVD/LD and TV/DBS input signal
mode (AUTO/ANALOG).
w
VOLUME
This control is used to raise or lower the volume level.
e
PHONES jack
When you use headphones, connect the headphones to the
PHONES jack. You can listen to the sound to be output from
the main speakers through the headphones.
When using headphones only, set both SPEAKERS A and B to
the OFF position and switch off the digital sound field processor
(so that no DSP program name appears on the display) by
pressing EFFECT.
r
SPEAKERS
Set A or B (or both A and B) to the ON position for the main
speaker system (connected to this unit) that you want to use.
Set the button(s) for the main speaker system you don’t want to
use to the OFF position.
t
A/B/C/D/E
Press this button to select one of a group (A to E) of preset
stations.
y
Preset station number selector
Each of these buttons selects a preset station number
(1 to 8).
u
Tone controls
These controls are only effective for the sound from the main
speakers.
BASS
Use this control to increase or decrease the low-frequency
response. The “0” position produces flat response.
TREBLE
Use this control to increase or decrease the high-frequency
response. The “0” position produces flat response.
i
BALANCE
This control is only effective for the sound from the main
speakers.
Turn the control to adjust the balance of the output volume to
the left and right speakers to compensate for sound imbalance
caused by the speaker location or listening room conditions.
o
RDS MODE
When an RDS station is received, pressing this button changes
the display into the PS mode, PTY mode, RT mode and/or CT
mode (if the station employs those RDS data services) in turn.
p
PTY SEEK MODE
When this button is pressed, the unit is set in the PTY SEEK
mode.
a
PTY SEEK START
Press this button to begin searching for a station after the
desired program type has been selected in the PTY SEEK
mode.
s
EON
Press this button to select the desired program type (NEWS,
INFO, AFFAIRS, SPORT) when you want to call a radio
program of that type automatically.
d
TIME/LEVEL
Press this button to select the item in the TIME/LEVEL mode.
f
+/–
These buttons are used to adjust the settings of the SET MENU
mode and the TIME/LEVEL mode. In the TIME/LEVEL mode,
press + to increase the delay time or speaker output level.
Press – to decrease the delay time or speaker output level.
g
SET MENU
Press this button to select functions in the SET MENU mode.
h
PROGRAM selector
Press or to select the DSP program.
The name of the selected program appears on the display.
j
EFFECT
This button switches on and off the output from the center and
rear speakers so that the sound becomes the normal
2-channel.
* Even if the output from the center and rear speakers is off,
when the Dolby Digital is decoded, the signals on all
channels are distributed to the main channels and output
from the main speakers.
k
VIDEO AUX terminals
Connect an auxiliary video or audio input source unit such as a
camcorder to these terminals. The source connected to these
terminals can be selected by INPUT.
01RX-V495RDS-1 6/22/99, 12:26 PM 8