Yamaha RX-V495RDS - Manual (Page 17)

17
English
Note
Use speakers with the specified impedance shown on the
rear panel of this unit.
Main speaker connections
One or two speaker systems can be connected to this unit. If
you use only one speaker system, connect it to either of the
SPEAKERS A or B terminals.
Rear speaker connections
A rear speaker system can be connected to this unit. Place
them to the rear of your listening position.
Center speaker connection
A center speaker can be connected to this unit. Place it on or
under the TV.
Subwoofer connection
You may wish to add a subwoofer to reinforce low frequencies
or to output low bass sound from the subwoofer channel.
If you have a subwoofer with built-in amplifier, including the
YAMAHA Active Servo Processing Subwoofer System, connect
the SUBWOOFER OUTPUT terminal of this unit to the input
terminal of the subwoofer system.
If you have a separate amplifier and subwoofer, connect the
SUBWOOFER OUTPUT terminal of this unit to the input
terminal of the subwoofer amplifier, and then connect the
speaker terminals of the subwoofer amplifier to the subwoofer.
When the input signals to this unit are for normal 2-channel
stereo, this terminal outputs only frequencies below 90 Hz from
the main and center channels. When discrete signals are input
to this unit and are selected as the input source, this terminal
outputs signals from the subwoofer channel.
Note: The output level of signals from this terminal is adjusted
by VOLUME on the front panel or VOLUME ( ) on
the remote control transmitter.
CONNECTING SPEAKERS
Rear speakers
Subwoofer system Center speaker
Right Left
Main speakers A Main speakers B
Right Left
Right Left
R L
REAR
(SURROUND) CENTER
MAIN
SUB
WOOFER
R L
OUTPUT
SPEAKERS
01RX-V495RDS-2 6/22/99, 12:26 PM 17