Zanussi ZDQ 895 - Manual (Page 40)

40
BEFORE CLEANING ALWAYS ALLOW
THE COOLING FAN TO COOL THE
APPLIANCE DOWN BEFORE SWITCHING
OFF AT THE ELECTRICITY SUPPLY.
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Abrasives must
also be avoided to prevent damaging the stainless
steel or painted finishes.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials, e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur.
Regularly wipe over the control panel, oven doors
and appliance sides using a soft cloth and hot soapy
water. To prevent streaking on stainless steel
models finish with a soft cloth. Any spillage on the
stainless steel finish must be wiped off
immediately.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface
finish.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.
CLEANING THE GRILL / TOP OVEN
COMPARTMENT
The grill / top oven compartment base, sides and
back panel can be cleaned using oven cleaners or
aerosol oven cleaners with care. Ensure that the
manufacturers instructions are followed and that all
parts are well rinsed afterwards.
Aerosol cleaners must not come into contact with
the grill element as this may cause damage.
CLEANING THE TOP OVEN ROOF
The grill element is hinged to make cleaning the oven
roof easier.
Switch off the appliance from the
electricity supply before cleaning and
ensure the oven is cold.
1. Remove the wirework side runners. See page 42.
2. Undo the two screws which hold the grill element
in place.
3. Gently pull the element downwards to allow
access to the oven roof. Do not force the element
downwards.
4. Clean the top of the oven with Cif cream cleaner
and a sponge scourer. If heavily soiled, aerosol
oven cleaners may be used following the
instructions given above for cleaning the grill / top
oven compartment.
5. Gently push the grill element back into place.
6. Fit the screws to hold the element in place and
tighten firmly.
7. Replace the wirework side runners.
Ensure the screws are firmly in place after
cleaning.
CARE AND CLEANING