Zanussi ZCM 1000X - Manual (Page 21)

21
FITTING THE STABILITY CHAIN
It is recommended that if the appliance is to be installed with a flexible supply pipe that a stability chain is fitted
and is available from your supplier (see Important Safety Requirements, Page 20). These instructions should be
read in conjunction with the leaflet packed with the stability chain.
1. Place the appliance in its intended position and level appliance.
2. Mark a position 100mm in from the to of the rear R.H. corner.
3. Measure down 150mm from this point. This gives the position of the wall anchor point for the stability chain.
4. The stability chain anchor point on the appliance is shown in the diagram fig 4.
INSTALLATION INSTRUCTIONS
Fig. 4