Zenoah HTZ7510 User Manual

Page 15

English

■ RUNNING IN THE ENGINE
During the first 20 working hours, do
not use the hedge-trimmer at
maximum power for long periods.

■ ADJUSTING IDLING SPEED

• Before adjusting the carburetor,

clean the air filter and warm up
the engine. (F5)

• Idle screw is adjusted in order to

ensure a good safety margin
between idle running and clutch
engagement. (F6)

(1) Air filter

(2) Idle screw

With the engine idling (3000 rpm),
the blade should not rotate. We
recommend that you have the
dealer or an authorised mechanic
carry out any carburetor
adjustments.

■ CUTTING WORK

• Weather conditions and altitude

may effect carburation.

• Do not allow anyone to stay

close to the hedge-trimmer
while working or while
adjusting the carburetor.

■ HOW TO USE

HANDLE [CHTZ6010 only] (F7)
To reduce fatigue when trimming
hedges, the handle can be swivelled
through 90° to the left or right.

Do not press the throttle during
this operation!

Proceed as follows:
1. Free the handle by pressing the

locking lever.

2. Turn the handle until the locking

lever clicks into place.

3. When the handle is locked in its

new position, you can apply the
throttle again.

(1) Handle
(2) Locking lever

WARNING

IMPORTANT

5. OPERATION

(2)

F7 [CHTZ6010]

This manual is related to the following products:

CHTZ6010