Zenoah HTZ7510 - Manual (Page 14)

14
[HTZ7510]
[CHTZ6010]
English
5. OPERATION
■ STARTING THE ENGINE
K e e p t h e b l a d e s c l e a r o f
everything around It as they will
s t a r t m o v i n g u p o n t h e e n g i n e
starts.
1. [HTZ7510] Make sure that the
throttle lever is at idling position.
[CHTZ6010] Release the throttle
lever and make sure it is fully
back. (F1)
2. [CHTZ6010] Set the engine switch
to the “I (RUN)” position. (F1)
3. P u s h t h e p r i m e r p u m p u n t i l
overflown fuel flows out in the
clear tube. (F2)
4. M o v e t h e c h o k e l e v e r t o t h e
closed position. (F3)
(1) Throttle lever (7) Stop
(2) Full throttle (8) Primer pump
(3) Idling (start position) (9) Clear tube
(4) Stop switch (10) Choke lever
(5) Engine switch (11) Open
(6) Run (12) Close
5. Place the unit on a flat, firm place.
Keep the cutting head clear of
everything around it.
6. While holding the unit firmly, pull
out the starter rope quickly. (F4)
• Avoid pulling the rope to its end or
returning it by releasing the knob.
Such actions can cause starter
failures.
7. Move the choke lever downward
to open the choke. and restart
engine. (F3)
8. Allow the engine to warm up for a
several minutes before starting
opertion.
1. W h e n r e s t a r t i n g t h e e n g i n e
i m m e d i a t e l y a f t e r s t o p p i n g i t ,
leave the choke open. (F3)
2. Overchoking can make the engine
hard to start due to excess fuel.
When the engine failed to start
after several attempts, open the
choke and repeat pulling the rope,
or remove the spark plug and dry
it.
■ STOPPING THE ENGINE (F1)
[HTZ7510]
1. Please return the throttle lever
completely.
2. Press the stop switch until the
engine comes to a complete stop.
[CHTZ6010]
1. Release the throttle lever.
2. Move the engine switch to the
“O(STOP)”position.
I f t h e e n g i n e d o e s n ’ t s t o p a f t e r
stopping the switch, close the choke
so that engine will stop after a little.
NOTE
NOTE
IMPORTANT
WARNING
(8)
F1
F2
F3
F4