Yamaha RX-396RDS/396 - Manual (Page 5)

5
English
Battery installation
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use only AA, R6, UM-3 batteries for replacement.
● Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
● Remove the batteries if the remote control transmitter is not
used for an extended period of time.
● If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
Remote control transmitter operation range
Notes
● There should be no large obstacles between the remote
control transmitter and the main unit.
● If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid direct
lighting.
1
3
2
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise this
unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE
STANDBY/ON SWITCH IS PRESSED;
The IMPEDANCE SELECTOR switch may not be set to
either end. If so, set the switch to either end when this unit is
in the standby mode.
l6 20 28
40
60
l2 8
4
2 0 –dB
30 ° 30
°
Remote control sensor
Within approximately
6 m (19.7 feet)
IMPEDANCE SELECTOR
A OR B:4 Ω MIN. /SPEAKER
A B:8 Ω MIN. /SPEAKER
A OR B: 6 Ω MIN. /SPEAKER
A B: I2 Ω MIN. /SPEAKER
IMPEDANCE SELECTOR
SET BEFORE POWER ON
A
(U.S.A. model)