Yamaha RX-396RDS/396 - Manual (Page 20)

20
EXCHANGING PRESET STATIONS
You can exchange the places of two preset stations with each
other as shown below.
Example)
If you want to shift the preset station on E1 to A5, and vice
versa.
STANDBY/ON
NATURAL SOUND STEREO RECEIVER
SPEAKERS PHONES
A
ON
B
OFF
BASS TREBLE BALANCE
VOLUME
5 5
4
3
2 l 0 l 2
3
4
5 5
4
3
2 l 0 l 2
3
4
L R
l6 20
28
40
60
l2
8
4
2
0 –dB
5 5
4
3
2 l 0 l 2
3
4
FM/AM
MAN’L/AUTO FM
TUNING MODE
AUTO/MAN’L MONO
DOWN TUNING UP
MEMORY EDIT
A/B/C/D/E 1 2 3 4 5 6 7 8
TUNER CD PHONO
AUX TAPE 1/MD TAPE 2 MONITOR
LOUDNESS
5 6 7
4
3
2 l FLAT
l0 –30dB
9
8
2, 4
1
Recall the preset station on E1 (by following the method
of “To recall a preset station” on page 18).
2
3
Recall the preset station on A5 by following the same
method as in step 1.
4
Flashes.
Flashes.
EDIT
EDIT
MEMO
MEMO
When the automatic preset tuning is finished;
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section “To recall a preset
station” on page 18.
To recall a preset station
Simply follow the procedure of the section “To recall a preset
station” on page 18.
*
A recalled station is shown by the frequency or station name
on the display.
*
A recalled station is shown by the frequency on the display.
Notes
● You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section “To store stations” on page 18.
● The automatic preset tuning search will be performed
through all RDS network frequencies until stations are stored
up to E8. If the number of received stations is not enough to
be stored up to E8, the search is finished automatically after
searching all frequencies.
● With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section “To store stations” on page 18.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large
volume of PI (Program Identification) data along with the
station.
● If the number of received stations is not enough to be stored
up to E8, the search is finished automatically after searching
all frequencies.
● With this function, only FM stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section “To store stations” on page 18.
RX-496RDS, RX-396RDS
RX-496, RX-396
RX-496 and RX-396 only
RX-496RDS and RX-396RDS only
Shows the exchange of
stations is completed.