Yamaha CDR400At - Manual (Page 13)

Chapter 2 - Installing the Yamaha CDR400At Drive
7
♦ Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON (with a jumper)
— Use this setting if the CDR400At is the last device in the internal
SCSI daisy-chain.
Terminator OFF (without a jumper)
— Use this setting if devices other than the CDR400At are in the inter-
nal SCSI daisy-chain and the CDR400At is not the last device.
♦ Block size setting
Block size ON (with a jumper)
— Block Size is set to 512Byte/sector. This function is valid only for
workstations, such as those that run UNIX.
Block size OFF (without a jumper)
— Normally, use this setting.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Terminator ON (default) Terminator OFF
* Use jumper connectors to short the locations shown in black.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Block size ON Block size OFF (default)
* Use jumper connectors to short the locations shown in black.