Yamaha CDR400At - Manual (Page 12)

Chapter 2 - Installing the Yamaha CDR400At Drive
6
Note: When you are using Windows 95, and if the SCSI ID setting on the rear
panel is the same as the number assigned to another SCSI device, the
Plug and Play component of Windows 95 will automatically assign an
unused number to the CDR400At (SCAM protocol level 1).
♦ Parity setting
Parity ON (with a jumper)
— Parity Check will be performed. Normally, use this setting.
Parity OFF (without a jumper)
— Parity Check will not be performed.
1 2 4
SCSI ID 1
1 2 4
SCSI ID 2
1 2 4
SCSI ID 3
1 2 4
SCSI ID 4
1 2 4
SCSI ID 5
1 2 4
SCSI ID 6
1 2 4
SCSI ID 7
1 2 4
SCSI ID 0
SCSI ID Setting
* Use jumper connectors to short the locations shown in black.
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Parity ON (default) Parity OFF
* Use jumper connectors to short the locations shown in black.