Zanussi ZJ 1284 - Manual (Page 16)

16
The water inlet filters
If your water is very hard or contains traces of lime
deposit, the water inlet filters may become clogged.
It is therefore a good idea to clean them from time to
time.
Turn off the water taps. Unscrew the water inlet hoses.
Remove and clean the filters using a hard bristle brush.
Replace the filters and tighten up the inlet hoses.
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
l Turn off the water taps.
l Unscrew the inlet hoses.
l Unhook the drain hose from the rear support and
position the end of this hose and that of the inlet
hoses in a bowl. Run the draining programme.
l Disconnect the appliance.
l Screw the inlet hoses and reposition the drain hose.
l When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
P0041