Yamaha CRW4001t - Manual (Page 9)

Chapter 1 - System Configuration
3
Chapter 1 - System Configuration
Before using the CRW4001t, make sure that you have all of the items
on the list of included items.
In order to use the CRW4001t, you will require the following.
Computer
The following operating environment is required:
• An IBM/AT compatible computer with a 100 MHz or faster Pentium
CPU (in order to write at 4x speed), or a 100 MHz or faster 486
CPU (in order to write at 2x speed)
• A vacant IDE interface connector
• A vacant half-height bay
• Windows 95
• Sufficient hard disk space
Note: You will need about twice as much space on your hard disk as that
required by the data you wish to write to CD-ROM.
Software
Use writing software or packet writing software which supports the
CRW4001t.
Tools
Philips screwdriver
• Philips screwdriver
This is used to remove the
cover of your computer,
and to install the Yamaha
CRW4001t drive.
• Long nose pliers
These are used to insert or
remove the jumper pin
when setting the MASTER/
SLAVE settings of the
Yamaha CRW4001t drive.
Long nose pliers