Main speaker, Lfe/bass out, Main level – Yamaha RX-V795aRDS User Manual

Page 30

3. MAIN SPEAKER

Choices: LARGE/SMALL
Preset position: LARGE

LARGE: If your main speakers have a high ability for bass

reproduction.
In this position, full range signals present at the main
channels are output from the main speakers.

SMALL: If your main speakers do not have a high ability for

bass reproduction. However, if your system does not
include a subwoofer, do not select this position.
In this position, low bass signals (below 90 Hz) at the
main channels are output from the SUBWOOFER
terminals (if the SW or BOTH position is selected on
“4. LFE/BASS OUT”).

4. LFE/BASS OUT

Choices: SW/MAIN/BOTH
Preset position: SW

MAIN:

If your system does not include a subwoofer.
In this position, full range signals present at the main
channels, signals from the LFE channel and other
low bass signals that are selected on “1. CENTER
SPEAKER” to “3. MAIN SPEAKER” to be distributed
from other channels are output from the main
speakers.

SW/BOTH:

Select either the SW or BOTH position if your system
includes a subwoofer.
In either position, signals at LFE channel and other
low bass signals that are selected on “1. CENTER
SPEAKER” to “3. MAIN SPEAKER” to be distributed
from other channels are output from the
SUBWOOFER terminals.
When the LARGE position is selected on “3. MAIN
SPEAKER”, in the SW position, no signal is
distributed from the main channels to the
SUBWOOFER terminals, however in the BOTH
position, low bass signals from the main channels
are output to both of the main speakers and the
SUBWOOFER terminals.

5. MAIN LEVEL

Choices: Normal (Nrml)/–10dB
Preset position: Nrml

Normal: Normally, select this position.

–10dB:

If the volume levels to the center and/or rear
speakers are lower than the level to the main
speakers even though they are adjusted to
maximum.
The volume level to the main speakers are
decreased by 10 dB, so you can adjust the speaker
output level balance properly.

PREPARATION

Note
The settings of “1. CENTER SPEAKER”, “2. REAR
SPEAKER”, “3. MAIN SPEAKER” and “4. LFE/BASS OUT”
have no effect on the signals input to the EXTERNAL
DECODER INPUT terminals on the rear of this unit.