Zenoah BC3401DL - Manual (Page 18)

18 
Optional Blade Usage
Change to the debris guard which is suitable for
the metal blade. (OPT3)
(1) Bolt
: 3540-24130 x 2 pieces
(2) Spring washer : 0290-20615 x 2 pieces
(3) Clamp
: 3541-24121
(4) Guard : 3541-24112
(5) Guard ass’y : 3541-24001
130~174 in-lbs
TIGHTENING TORQUE:
(14.7~19.6 N.m.)
Change the loop handle to the J-handle for safe
operation. (OPT4)
(1) Bracket : 3532-14102
(2) J-handle : 6367-14200
■ STARTING ENGINE
Please refer to P.15
■ STARTING ENGINE
• The product is equipped with a centrifugal
clutch mechanism, so the cutting attachment
begins to rotate as soon as the engine is
started by putting the throttle into the start
position. When starting the engine, place the
product onto the ground in a flat clear area
and hold it firmly in place so as to ensure that
neither the cutting part nor the throttle come
into contact with any obstacle when the
engine starts.
■ CUTTING METHOD
a) Use the front left side cutting.
b) Guide the blade from your right to left with it
tilted slightly to your left. (OPT6)
c) When mowing a wide area, start working from
your left end to avoid interference of cut grass.
d) The blade may be seized by weeds if the engine
speed is too low, or the blade cuts too deep into
weeds. Adjust the engine speed and cutting
WARNING
IMPORTANT
IMPORTANT
OPT4
OPT6
OPT3
FOR BC3401DL
OPT5