Set up – Zenoah BC3401DL User Manual

Page 12

■ PUTTING ON WAIST PAD
(BC4401DW only)
• Warp the waist pad around the shaft tube

and the throttle wire.

■ INSTALLING CUTTING HEAD
1. While locking the gear shaft by inserting

the attached bar into the upper holder and
the gear box, loosen and remove the
hexagon bolt(left-handed)

2. Fit the spacer attached to the head

assembly between the upper and lower
holders. Then screw in the cutting head to
the gear shaft over the holders. Hand-
tighten it securely.

12 

Set Up