Zenoah BK2650DL - Manual (Page 12)

GB-12
BK2650DL
8. Operation
PUTTING ON THE UNIT
NOTE
• When carrying the unit on the back, make sure that
the throttle lever is set to the idling position and that
the throttle wire will not become twisted and tensioned.
1. After confirming that there is no person or obstacle
nearby, grasp the end of the main pipe handle (cutter
head side) with the left hand and put the right shoul-
der strap around the right shoulder.
2. Hold the main pipe with the right hand and put the left
shoulder strap around the left shoulder.
3. Join the right and left shoulder straps in front of the
chest.
4. Adjust the length of the right and the left shoulder straps
to fit the body of the operator so that the back cushion
is slightly above waist level and the weight of the unit
is equally carried by the right and left shoulders.
How to adjust the length of the shoulder strap
Pull down the end of the strap.
HOW TO OPERATE THE EMERGENCY RELEASE PINCH
In case of emergency, pinch the depressed portions (1
and 2) on the hook of the shoulder strap. The shoulder
strap will then be released from the shoulder and the
brush cutter will be separated from the body.
• By using the shoulder strap, hang the unit on your
right side. Adjust the strap length so that the cutting
head may become parallel to the ground.
Pull up the bottom end of
the buckle.
WARNING
• Make sure to use shoulder strap and debris guard.
If not, it is very dangerous when you slip or lose
your balance.
CUTTING WORK
WARNING
1. Always wear eye protection such as safety
goggles. Never lean over the rotating cutting head.
Rocks or other debris could be thrown into eyes
and face and cause serious personal injury.
2. Keep the debris guard in place at all times when
the unit is operated.
TRIMMING GRASS AND WEEDS
• Always remember that the TIP of the line does cut-
ting. You will achieve better results by not crowding
the line into the cutting area. Allow the unit to trim at
its own pace.
1. Hold the unit so the head is off the ground and is tilted
about 20 degrees toward the sweep direction.
2. You can avoid thrown debris by sweeping from your
left to the right.
3. Use a slow, deliberate action to cut heavy growth.
The rate of cutting motion will depend on the material
being cut. Heavy growth will require slower action than
will light growth.
4. Never swing the unit so hard as you are in danger of
losing your balance or control of the unit.
5. Try to control the cutting motion with the hip rather
than placing the full workload on the arm and hands.
6. Take precautions to avoid wire, grass and dead, dry,
long-stem weeds from wrapping around the head
shaft. Such materials can stall the head and cause
the clutch to slip, resulting in damage to the clutch
system if repeated frequently.