Zanussi ZYB992 - Manual (Page 17)

3 Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove the door
from its seat.
4 Put the door on a soft
cloth on a stable surface.
5 Release the locking
system to remove the pan-
els of glass.
90°
6 Turn the two fasteners
by 90° and remove them
from their seats.
2
1
7 Carefully lift (step 1)
and remove (step 2) the
panels of glass one by
one. Start from the top
panel of glass.
Clean the glass panels with water and soap. Dry the glass
panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the glass panels
and the oven door. Do the above steps in the opposite se-
quence.
Make sure that you put the
glass panels back in the
correct sequence.
Make sure that you install
the top panel of glass in
the seats correctly.
The middle panels have a decorative frame. When you in-
stall the middle panels, make sure that the screen-printing
zone looks to the inner side of the door. Make sure that
after the installation the surface of the glass panel frame
on the screen-printing zones is not rough when you touch
it.
What to do if…
Warning! Refer to "Safety information" chapter.
Problem Possible cause Remedy
The appliance does not heat
up.
The appliance is deactivated. Activate the appliance.
17