beautypg.com

Water outlet hose connection – Zanussi DWS 939 User Manual

Page 21

background image

21

Water outlet hose connection

The end of the drain hose can be connected in the
following ways:

1. To the sink outlet siphon, securing it if necessary

with a clip.

2. Hooked over the edge of the sink using the special

curved plastic guide provided.

3. To a stand pipe provided with vent-hole, minimum

internal diameter 4 cm.

The waste connection must be at a height of between
30 cm (minimum) and 100 cm (maximum) from the
bottom of the dishwasher.

The drain hose can face either to the right or left of the
dishwasher

Ensure the hose is not bent or squashed as this could
prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer
than 2 metres and its internal diameter must be no
smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used
for connections to the waste outlet must be no smaller
than the diameter of the hose provided.

The sink plug must not be in place when the
machine is draining as this could cause the water
to siphon back into the machine.

COL09en

min 30 cm

max 100 cm

min 4 cm

Ш 21

Ш 18

CS09

2

3

1

max 100 cm

min 30 cm

max 100 cm

max 100 cm

+ 2 m max

CS10

Ш 18

Ш 21