Yamaha RX-V365 - Manual (Page 32)

28
En
FM/AM tuning
y
• You can select the preset station group and the preset station number
where the first received station will be stored by pressing EA/B/C/D/E
and then FPRESET/TUNING l / h.
Notes
• Any stored station data existing under a preset station number is cleared
when you store a new station under the same preset station number.
• Only FM stations with sufficient signal strength are stored automatically
by automatic preset tuning. If the station you want to store is weak in
signal strength, tune it manually and store it as described in “Manual
station preset” on this page.
Use this feature to store the FM or AM stations manually.
1
Tune into a station.
See page 27 for using instructions.
2
Press HMEMORY.
The MEMORY indicator flashes on the front panel
display for approximately 30 seconds.
3
Press EA/B/C/D/E and FPRESET/TUNING
l / h repeatedly to select a preset station
group and number (A1 to E8) while the
MEMORY indicator is flashing.
Check that the colon (:) appears on the front panel
display.
• To select a higher preset station group and number,
press FPRESET/TUNING h.
• To select a lower preset station group and number,
press FPRESET/TUNING l.
4
Press HMEMORY while the MEMORY
indicator is flashing.
The station band and frequency appear on the front
panel display with the preset station group and
number you have selected.
You can tune into any desired station simply by selecting
the preset station group and number under which it is
stored.
1
Press EA/B/C/D/E (or ll / h) repeatedly to
select the desired preset station group (A to
E).
The preset station group letter appears on the front
panel display and changes each time you press the
button.
2
Press FPRESET/TUNING l / h (or lk /
n) to select the desired preset station
number (1 to 8).
The preset station group and number, along with
station band and frequency, appear on the front panel
display.
y
• You can select the desired preset station number (1 to 8) directly by
pressing the numeric buttons (y).
You can exchange the assignments of two preset stations
between the two. The example below describes the
procedure to exchange preset station “E1” and “A5.”
1
Select preset station “E1” using EA/B/C/D/E
and FPRESET/TUNING l / h.
See “Selecting preset stations” on this page.
2
Press and hold DEDIT PRESET/TUNING
for more than 3 seconds.
“E1” and the MEMORY indicator flash on the front
panel display.
3
Select preset station “A5” using EA/B/C/D/E
and FPRESET/TUNING l / h.
“A5” and the MEMORY indicator flash on the front
panel display.
See “Selecting preset stations” on this page.
4
Press DEDIT PRESET/TUNING again.
“EXCHANGE E1-A5” appears on the front panel
display and the assignments of the two preset stations
are exchanged.
Manual station preset
Selecting preset stations
When performing this operation with the remote
control, press fTUNER to select “TUNER” as the
input source.
TUNED MEMORY
: C3 AM 630 kHz
Flashes
Preset station group and number
TUNED
: C3 AM 630 kHz
The displayed station has been stored as C3.
Exchanging preset stations
: E1 FM 87.5 MHz
MEMORY
: E1 FM 87.5 MHz
Flashes
Flashes
MEMORY
: A5 FM 90.5 MHz
Flashes
Flashes