Yamaha RX-N600D - Manual (Page 97)

95
En
ADVANCED SETUP
AD
V
A
N
C
ED
OPERA
T
ION
■ Speaker impedance
SP IMP.
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8
ΩMIN, 6ΩMIN
• Select “8
ΩMIN” to set the speaker impedance to 8 Ω .
• Select “6
ΩMIN” to set the speaker impedance to 6 Ω .
■ Factory presets
PRESET
Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 111).
Choices: CANCEL, RESET
• Select “CANCEL” not to reset any parameters of this
unit.
• Select “RESET” to reset the parameters of this unit.
• This setting completely resets all the parameters of this unit
including the “SET MENU” parameters. However, the
advanced setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
■ Network reset
N-RESET
Use this feature to reset the network settings of this unit
(see page 90) to the initial factory settings.
Choices: CANCEL, RESET
• Select “CANCEL” not to reset any network settings of
this unit.
• Select “RESET” to reset the network settings of this
unit.
• The initial factory settings are activated next time you turn on
this unit.
• When the network settings are reset, “DHCP” in “NET/USB
MENU” is automatically set to “ON” (see page 90) and the
registered client ID of this unit on your YAMAHA MCX-2000
is cleared (see page 108).
■ Remote control AMP ID
REMOTE AMP
Use this feature to set the AMP ID of this unit for remote
control recognition (see page 99).
Choices: ID1, ID2
• Select “ID1” when the remote control AMP ID library
code is set to “00001”.
• Select “ID2” when the remote control AMP ID library
code is set to “00002”.
You need to set the corresponding remote control AMP library
code for the remote control (see page 99).
■ Remote control TUNER ID
REMOTE TUN
Use this feature to set the TUNER ID of this unit for
remote control recognition (see page 99).
Choices: ID1, ID2
• Select “ID1” when the remote control TUNER ID
library code is set to “81916”.
• Select “ID2” when the remote control TUNER ID
library code is set to “81917”.
You need to set the corresponding remote control TUNER library
code for the remote control (see page 99).
SP IMP. Speaker Impedance level
8 ΩMIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 8
Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16
Ω or
higher. *
Center
The impedance of each
speaker must be 8
Ω or
higher.
Surround
Surround back
6
ΩMIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 4
Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8
Ω or
higher.
Center
The impedance of each
speaker must be 6
Ω or
higher.
Surround
Surround back
Notes
Notes
Note
Note