Zanussi ZJB 9476 X - Manual (Page 30)

30
Building the appliance in
• Fit the appliance into the recess.
• Rotate the bracket of 180° in order to obtain the
right position ( 2).
The position (1) is on the delivery.
• Fix it to the wali with the appropriate bracket.
• The top of the appliance must be kept ciear to
allow better air circulation. If a wall unit is fitted
above the appliance, there must be a gap of 50
mm between this unit and the wall and it must be
at least 50 mm below the ceiling.
Fitting the plinth
Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make a cut-out
as shown.
• If using a plinth higher than 100 mm but less than
140 mm, cut the height compensation strip
supplied with the appliance to the required depth
and fit it between the plinth and the ventilation
griile, pressing it into position below this grille.
25
50
50
870
820
140
190
30
100
900
170
220
140
190
1
2