Xantrex Technology 600 - Manual (Page 22)

18 xPower600 Owner’s Manual
8.0 Recharging xPower600
8.1 General Information on Batteries and
Charging
8.1.1 Charging Options
These charging options are possible with xPower600:
· Charging with the fully automatic “plug-in-and-forget”
AC Charger.
· Charging from your vehicle as you drive with the
DC Charging Cable.
· Charging from a generator equipped with a 12 Volt
battery charging outlet.
· Charging from a solar panel.
8.1.2 Battery Self-Discharge and Shelf Life
All rechargeable batteries gradually discharge when left standing.
Periodic charging is necessary to maintain maximum battery
capacity. The AC Charger supplied with xPower600 is designed to
regulate the charging process, ensuring the battery is always fully
charged, but never overcharged. To ensure safe recharging and
maximum battery life, charge only with Xantrex supplied or
approved products.
CAUTION: Due to inherent self-discharge, lead acid batteries must be
charged at least every 3 months, especially in a warm environment.
Leaving a battery in a discharged state, or not recharging every 3 months,
risks permanent damage.
CAUTION: Do not attempt to recharge xPower600’s battery if it is frozen.
A frozen battery should be gradually warmed to 32°F (0°C) before
charging.
8.2 Recharging with the AC Charger
xPower600’s 5 Amp AC Charger offers the convenience of “plug-in-and-
forget” recharging.
To use the AC Charger, follow these steps:
1. Disconnect any 12 Volt DC accessories and turn the AC Outlets
Switch off.
2. Insert the DC plug end into the DC Power Socket, which is also
labeled Charger Input.