Yamaha EMX100RDS - Manual (Page 37)

E-29
English
RECEIVING RDS STATIONS
CD CHANGER RECEIVER EMX–100RDS
PHONES
DISC 1 2 3
PROGRAM
MUSIC
USER MEMORY
INPUT SELECTOR VCR/LD-TV/CD/TUNER/TAPE•MD/AUX VOLUME
RANDOM
DISPLAY MIC
MIN MAX
MIC MIXING
REPEAT TIME MEMORY AUTO/MAN'L
HOUR PRESET/TUNING/BAND A/B/C/D/E MIN TIME ADJ TIMER
OPEN/
CLOSE
DISC
CHANGE
STANDBY/ON
MODE PTY SEEK START FREQ PS/PTY/RT/CT
PTY SELECT PTY SELECT
➀
ON (OFF) CT
>
CLOCK
This unit corrects the time of the built-in clock
automatically by synchronizing it with the CT data on the
RDS station being received.
* If you receive an RDS station of some other country,
the built-in clock is synchronized with the time setting
of the country.
* If the built-in clock is not yet set for current time or
reset due to a power failure etc., it will be set for the
time of the CT data automatically, whether this setting
is ON or OFF.
➁
ON (OFF) LOCAL
>
CT
If the RDS station being received employs the local time
(summer time etc.) data service, its time is displayed in
the CT mode.
* If the setting of function
➀
is “ON”, the built-in clock is
synchronized with the local time data.
➂
ON (OFF) A. M.
>
RDS
Only RDS stations are searched instead of all FM
stations by the automatic preset tuning operation when
the setting is ON.
(Refer to page 25 for the operating procedure.)
If you switch this function OFF, not only RDS stations but
also other FM stations are programmed along with MW
and LW stations by the automatic preset tuning
operation.
To switch these functions on and off
1
Select the FM band by pressing the
PRESET/TUNING/BAND button, confirming it on the
display.
2
Press the DISPLAY button to display the current time.
3
Press the FREQ PS/PTY/RT/CT selector button.
The title of function
➀
“ON CT
>
CLOCK ” is displayed.
4
Select the title of function whose setting you want to
switch by pressing the PTY SEEK MODE button once or
more.
5
Switch the function ON or OFF by pressing the PTY SEEK
START button, confirming it on the display.
6
Press the FREQ PS/PTY/RT/CT selector button again to
restore the frequency display mode.
* If the station has PS data, after the frequency display
mode returns, it turns into the PS mode.
Notes
● Once the setting is changed, it will be stored until it is
changed again by the above operation.
● During the operation, if there is no operation for about 20
seconds, this mode is canceled and turns into the
frequency display. If the station has PS data, after that, it
turns into the PS mode.
1
2
3
REPEAT
HOUR
MODE PTY SEEK
Other functions which make use
of RDS data service
This unit has the following functions which make use of RDS
data service. These are originally in operation [ON].
However, you can cancel these functions [OFF], if so
desired.
3, 6 4 5
1 2