Yamaha EMX100RDS - Manual (Page 19)

E-11
English
ANTENNA
AM
FM
GND
75 Ω
UNBAL.
ANTENNA
AM
FM
GND
75 Ω
UNBAL.
(1)
(2)
(3)
(4)
ANTENNA
AM
FM
GND
75 Ω
UNBAL.
VCR MONITOR OUT
ANTENNA
AM
FM
GND
75 Ω
UNBAL.
NORMAL
PHANTOM
CENTER MODE N OUT
EO SIGNAL
Antenna connection
(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal
and direct the FM antenna wire to the direction where the
strongest signal can be received.
(2) Supplied AM (MW/LW) loop antenna
Connect the AM (MW/LW) loop antenna wires to the
corresponding terminals. Position the AM (MW/LW) loop
antenna for optimum reception. Place the AM (MW/LW) loop
antenna on a shelf etc., or install it on the rack or wall with
screws (not supplied).
Notes
• When static is still heard even after adjusting the position
of the AM (MW/LW) loop antenna, try reversing the wire
connections (from the upper terminal to the lower one,
and vice versa).
• Do not place the AM (MW/LW) loop antenna on the unit. It
will result in noise generation, since the unit is equipped
with digital electronics. Place the AM (MW/LW) loop
antenna away from the unit.
(3) External FM antenna
Use an external FM antenna instead of an indoor FM
antenna if you need better reception. Consult your dealer.
(4) External AM (MW/LW) antenna
Use an external AM (MW/LW) antenna if you need better
reception. Consult your dealer.
Note
When using an external AM (MW/LW) antenna, be sure to
keep the wire of the AM (MW/LW) loop antenna connected.
CONNECTIONS
or
15 m (49 feet)
7.5 m (25 feet)
Earth rod