Yakumo Accelerator PC Trainer Plus PT18 - Manual (Page 6)

2
Caution
• Do not mix different types of batteries or old and new batteries.
• Only use batteries of the same or equivalent type as recommended.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not going to be used
for long periods of time.
• Do not dispose of batteries in fire.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before
being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
Caution
• The unit must not be connected to a power supply greater than 9V.
• Only use the recommended adaptor.
• The adaptor is not a toy.
• Do not short-circuit the supply terminals.
• Toys liable to be cleaned with liquid are to be disconnected
from the transformer before cleaning.
Chapter 2 Chapter 2
Getting Started The Accelerator PC Trainer Plus operates on 4 AA size batteries (not included) or a 9V AC
adaptor (sold separately).
AC Adaptor Connection
Plug the adaptor into the adaptor jack
(center positive type) on the left side of the unit.
Plug the adaptor into a wall outlet.
Pls. turn off the unit before plugging in the AC
adaptor. Otherwise the unit may be damaged.
Battery Installation
1. Make sure the unit is turned off.
2. Using a Phillips-head screwdriver, open the battery cover at the back of the unit.
3. Insert 4 “AA” batteries. (Note the correct polarity: +, - ).
4. Replace the cover.
+
-
PT18-Manual (US) 6/14/02 5:53 PM Page 6