ZyXEL Communications A-6000 - Manual (Page 18)

17
6. Connect the antenna to the N-male connector port labeled on the top of outdoor unit. For the
directional antenna installation, use the HDF 400 RF coaxial cable. The polarization of antenna for both
BU and RU should be the same;
otherwise, the installation will fail to communicate. At the same time, you have
to point the directional antenna to that of the other unit.
Notice: The antenna must be installed by the professional installer to comply with the safety, electrical
and radiation standards. The installer should properly configure the output power of transceiver
according to related country regulation requirement and per antenna type.
Figure 5-6 Install Antenna to the Outdoor Unit
Attach the end of 8-pin male connector of category-5 cable to the 8-pin female connector port labeled
on the bottom of outdoor unit. Then, the outdoor unit installation is completed.
Figure 5-7 Connect Cat-5 cable to the outdoor unit