Waring PRO High Powered Blender MX1000R - Manual (Page 6)

• In repetitive batch-processing applications, frequent cleaning of the
container will prolong the life of the blade assembly. In no case should
actual running time between cleanings exceed 1/2 hour.
• Do not use container to store processed foods or beverages.
To wash and rinse container:
1. REMOVE CONTAINER FROM MOTOR BASE. Remove lid. Rinse
container interior and lid under running water. Add washing solution to
container. Scrub and flush out the container interior and lid to dislodge
and remove as much food residue as possible. Empty container.
2. Wipe down exterior of container with a soft cloth or sponge dampened
with washing solution. Wash lid and lid insert in fresh washing solution.
Fill container 1/4 full with fresh washing solution, cover (with lid only but
without center piece), place on motor base and run on HI for two (2)
minutes. Empty container.
3. Repeat step (2) using clean rinse water in place of washing solution.
IMPORTANT
NOTE: IN ORDER TO MINIMIZE POSSIBILITY OF SCALDING, TEMPERATURE
OF WASHING SOLUTION AND RINSE WATER MUST NOT EXCEED 115˚F
(46˚C), AND QUANTITY USED MUST NOT EXCEED 1/4 CONTAINER FULL.
IF HIGHER TEMPERATURES OR LARGER QUANTITIES ARE USED, OBSERVE
ALL PRECAUTIONS GIVEN IN THE OPERATING MANUAL UNDER “HOT
BLENDING INSTRUCTIONS”.
To sanitize and dry container:
1. Wipe down exterior of container with a soft cloth or sponge dampened
with sanitizing solution.
2. Fill container with sanitizing solution, cover, place on motor base, and run
on high speed for two (2) minutes. Empty container. Dislodge any residual
moisture from blade assembly by placing empty container on motor base
and running on high speed for two (2) seconds.
3. Sanitize lid and lid insert by immersing in sanitizing solution for two
(2) minutes.
4. Do not rinse container, lid, or lid insert after sanitizing is completed.
Allow parts to air-dry.
To clean and sanitize motor base:
1. UNPLUG POWER CORD. Wipe down exterior surfaces of motor base with
soft cloths or sponges dampened with washing solution, rinse water, and
sanitizing solution. Prevent liquid from running into motor base by wring-
ing all excess moisture from cloths or sponges before using them.
DO NOT IMMERSE MOTOR BASE IN WASHING SOLUTION, RINSE WATER
OR SANITIZING SOLUTION.
2. Allow motor base to air-dry before using.