Whirlpool 15080000 - Manual (Page 18)

Document ID:15080000 Rev: E Technical Support: 800-626-6912 Page 18 of 20
Removing / Replacing Drain Handle
Tools needed:
Phillips head screwdriv er
Check y our state and local regulations for cleaning procedures. Links to y our state boards can be f ound on our web site, at
www.europeantouch.com. Ref er to the cleaning procedure page headed “Crystal Clean™ Pipe-Free ® Spa - Cleaning and Disinf ecting
Procedures,” page 17.
Follow the steps below for cleaning and replacing parts.
Step 1: To remove the chrome
drain handle, loosen the set
screw in the slot on the
drain handle and slip off
chrome handle from chrome
handle post.
Step 2: Picture, with the drain
handle removed, shown for
cleaning reference.
Picture, of drain plunger removed,
shown for cleaning
reference.
Removing / Replacing Impeller
Check your state and local regulations for cleaning procedures. Links to your state boards can be found on our web site,
at www.europeantouch.com. Refer to the cleaning procedure page headed “Crystal Clean™ Pipe-Free ® Spa - Cleaning
and Disinfecting Procedures,” page 17, for cleaning recommendations.
Follow the steps below for cleaning and replacing parts.
Step 1: Remove the tee knobs (2) by
turning counter clockwise.
Step 3: Remove the impeller knob by
turning counter clockwise.
Step 5: Once parts are clean,
complete steps one through four in
reverse order to replace the parts.
Step 2: Lift the footplate to remove. Step 4: Lift the impeller. Step 6: Press firmly down on footplate
to help seal while
simultaneously tightening tee
knobs.