weber Genesis Silver-C - Manual (Page 22)

C-4
Connect the side burner hose as follows:
1)
Slide back the collar of the quick disconnect
on the manifold.
2) Push the male fitting of the side burner hose
into the quick disconnect, and maintain
pressure. Slide the collar closed.
(1)
(2)
Quick disconnect will be engaged.
Check to be sure that the side burner valve is OFF.
Push the side burner control knob down and turn it
clockwise. If it doesn’t turn, the valve is OFF. If it does
turn, continue turning it clockwise until it stops, then
the burner is OFF.
Install the left end trim piece and swing-up work
surface
You will need: End trim piece, swing-up work surface,
swing-up work surface rod, two 1/2 inch bolts, two
nylon washers and a wrench
1.) Start the left end trim piece into the frame as
shown, do not push the trim piece in all of the
way and do not add bolts yet.
2.) Slide the swing-up work surface rod through the
holes at the top of the swing-up work surface.
3.) Insert one end of the swing-up work surface rod
into the hole in the frame.