Wacom DTF-521 - Manual (Page 12)

Installation
Page 10
INSTALLATION
SYSTEM REQUIREMENTS
Before installing the DTF-521, make sure your computer meets the following minimum system
requirements:
• PC. Windows Vista ™ , Vista X64, XP, XP x64, or 2000. VGA video connector, available USB port,
and CD-ROM drive.
• Macintosh. OS X, v10.3.9 or greater. VGA video connector, available USB port, and
CD-ROM drive.
Notes: The DTF-521 can be used alone or with another display. You may connect a second VGA device such
as a monitor or LCD projector to the DTF-521
ANALOG RGB OUT port. When using this port, the second
device will mirror the image on the DTF-521. Complete the DTF-521 installation before connecting a
projection device to the unit.
Depending on the capabilities of your video card and operating system, you may be able to set up the
DTF-521 as a mirrored, extended, or independent display. Refer to your video card documentation for more
information on its capabilities.
When you are working with more than one monitor, the DTF-521 will map to the monitors based upon how
your system is configured. By default, if you are in mirror mode, the pen tablet will map to the entire space on
each display or monitor. Please refer to your hardware and operating system documentation for details on
configuring your computer and operating system for use with multiple monitors.
There are two primary steps to the installation process:
• Step 1: LCD monitor installation
• Step 2: Pen tablet installation
Be sure to follow ALL instructions carefully.
DTF521_Manual.fm Page 10 Thursday, October 25, 2007 3:46 PM