Whirlpool YGSC308 - Manual (Page 7)

7
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the ovens, Timer and Timed Cooking
are off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK, START or START/ADD A MINUTE.
To remove the time of day from the display: Touch and hold
CLOCK for 5 seconds.
To return the time of day to the display: Touch CLOCK. The
time should not have to be reset.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid pad touch
■ Oven is preheated
■ Function has been entered
Three tones
■ Invalid pad touch
Four tones
■ End of cycle
■ Reminder, repeating each minute after the end-of-cycle tones
All Tones
All of the above tones are preset on, but can be turned off.
To Turn Off/On: Touch and hold STOP TIME for 5 seconds. A
tone will sound, and “Snd oFF” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd on.”
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Touch and hold the number pad “7” for 5 seconds. A
tone will sound, and “Snd Lo” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd HI.”
Reminder Tones
The Timer arnd Timed Cooking reminder tones are preset on, but
can be turned off. Reminder tones do not include end-of-cycle
tones. If “All Tones” have been turned off, the reminder tones
cannot be turned on independently.
Timer
To Turn Tones Off/On: Touch and hold TIMER SET until a tone
sounds. Repeat to turn back on.
Timed Cooking
To Turn Tones Off/On: Touch and hold COOK TIME until a tone
sounds and the lower oven display returns to inactive mode
(blank). Repeat to turn back on.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Touch and hold CUSTOM BROIL for 5 seconds. A
tone will sound, and “C” will appear on the display. Repeat to
change back to Fahrenheit. To remove, touch UPPER OFF,
LOWER OFF or OFF/CANCEL.
Timer
The Timer can be set in minutes and seconds or hours and
minutes, and counts down the set time. The Timer does not start
or stop the oven.
To Set:
1. Touch TIMER SET.
Touch again to switch between MIN/SEC and HR/MIN.
If no action is taken after 1 minute, the upper oven display will
return to the time of day mode.
2. Touch the number pads to set length of time.
3. Touch TIMER SET or START/ADD A MINUTE.
If not touched within 5 seconds, the display will return to the
time of day mode and the programmed function will be
canceled.
When the set time ends, if enabled, end-of-cycle tones will
sound, then reminder tones will sound every minute.
4. Touch TIMER OFF anytime to cancel the Timer and/or stop
reminder tones.
Remember, touching the Off/Cancel pads will turn off the
respective oven.
The time can be reset during the countdown by repeating the
above steps.
Control Lock
The Control Lock shuts down the control panel pads to prevent
unintended use of the ovens.
When the control is locked, only the CLOCK, TIMER SET and
TIMER OFF pads will function.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control: Before locking, make sure the ovens,
Timer and Timed Cooking are off. Touch and hold START until
3 tones sound and “CONTROL LOCK” and a picture of a lock
appear on the lower oven display, about 3 seconds. Repeat to
unlock and remove “CONTROL LOCK” from display.
Number Codes
The oven is preset with shortcut number codes for High Speed
and Microwave Cooking. A number code includes one or more of
the following; cooking power, cook time and food quantity or
weight. See the code charts in the “High Speed Cooking,”
“Custom Reheating,” “Custom Defrosting” and “Popcorn”
sections for additional information.
Help Prompts
Help prompts are visible messages that appear on the upper
oven display.
Before turning help prompts on/off, both ovens, the Minute Timer
and any lower oven Timed Cooking must be off.
To Turn Off/On: Press and hold the number pad “2” for
5 seconds. A tone will sound, and either “HELP OFF” or “HELP
ON” will flash on the upper oven display for 3 seconds. Repeat
for desired option.