Weslo E 20 - Manual (Page 6)

6
29
1
2
3
3. Loosen the Frame Knob (29) on the right side of the
Frame (1). Slide out the Seat Frame (2) until it
stops. Tighten the Frame Knob.
2. Attach the Handlebar (37) to the Upright (3) with two
M10 Split Washers (54) and two M10 x 25mm
Button Head Screws (53).
1. Carefully slide the Upright (3) onto the Frame (1),
while pulling the excess Reed Switch Wire (42) and
Resistance Cable (31) up through the Upright.
Attach the Upright with three M10 x 25mm Button
Head Screws (53) and three M10 Split Washers
(54). Be careful not to pinch the Reed Switch
Wire or the Resistance Cable.
1
2
3
54
54
53
53
31
3
42
4. The Console (33) requires two “AA” batteries (not
included); alkaline batteries are recommended.
Open the battery door on the back of the Console.
Press two batteries into the Console. Make sure
that the negative (–) ends of the batteries are
touching the springs. Close the battery door.
53
37
53
54
54
Hole
4
Back of
Console
Battery Door
Batteries
33
1
Be careful not
to pinch the
Reed Switch
Wire or the
Resistance
Cable.