Weider 831.150310 - Manual (Page 8)

8. Insert the Backrest Bracket (10) into the slot in
the Bench Frame (1).
Lubricate an M10 x 168mm Bolt (41) with grease.
Attach the Backrest Tubes (12) to the Bench
Frame (1) with the Bolt and an M10 Nylon
Locknut (48). Do not overtighten the Locknut;
the Backrest Tubes must be able to pivot easi-
ly.
8
6
48
34
26
26
26
51
47
30
47
42
35
Lubricate
33
16
3
2
6. Press three 45mm Square Inner Caps (26) into
the Leg Lever (3). Press a 25mm Round Inner
Cap (33) into the Weight Tube (16).
Attach the Weight Tube (16) to the Leg Lever (3)
with an M8 x 58mm Bolt (42), two M8 Washers
(47), a 10mm Spacer (30), and an M8 Nylon
Locknut (51). Press a 25mm Round Angled Cap
(34) onto the end of the Weight Tube.
Lubricate an M10 x 65mm Bolt (35) with grease.
Attach the Leg Lever (3) to the Front Leg (2) with
the Bolt and an M10 Nylon Locknut (48). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
7. Press four 25mm Square Inner Cap (28) into two
Backrest Tubes (12).
Attach the Backrest Tubes (12) to the Backrest
Bracket (10) with four M6 x 38mm Bolts (40), four
M6 Washers (50), and four M6 Nylon Locknuts
(52).
52
52
10
28
28
40
12
50
50
50
50
40
10
41
48
Lubricate
1
7
8
5
5. Attach the Bench Frame (1) to the center holes in
the Crossbar (4) with two M10 x 82mm Bolts (43)
and two M10 Nylon Locknuts (48).
Tighten the M10 Nylon Locknuts (48) used in
steps 1–5.
48
1
43
43
4
Center
Holes
12