beautypg.com

Stopping and restarting, Drying, cycle and temperature tips, Dryer symbols – Whirlpool 3XWED5705SW0 User Manual

Page 8: Cycle descriptions

background image

8

3. Turn the Cycle Control knob to the recommended cycle for

the type of load being dried. See “Drying, Cycle and
Temperature Tips.”

4. Select a temperature setting on models with a Temperature

selector. The cycle descriptions include temperature setting
suggestions.

NOTE: The temperature selector is part of the Cycle Control
knob on some models.

5. Select the End of Cycle Signal, if available. The signal is

helpful when drying permanent press or synthetics. Promptly
remove these items from the dryer at the end of the cycle to
help avoid wrinkles.

6. Press PUSH TO START. Your gas dryer has an electronic

ignition system for the burner which is fully automatic; no
action is needed by the user (there is no pilot light).

NOTE: Your dryer stops automatically when a cycle ends.

Stopping and Restarting

You can stop your dryer anytime during a cycle.

To stop your dryer

Open the dryer door or turn the Cycle Control knob to OFF.

NOTE: The Cycle Control knob should point to an Off area when
the dryer is not in use.

To restart your dryer

1. Close the door.

2. Select a new cycle and temperature (if desired).

3. Press the Start button.

Drying, Cycle and Temperature Tips

Select the correct cycle and temperature for your load.

Cool Down tumbles the load without heat during the last few
minutes of all cycles to make the load easier to handle.

Drying tips

Follow care label directions when they are available.

If desired, add a fabric softener sheet. Follow package
instructions.

Remove the load from the dryer as soon as tumbling stops, to
reduce wrinkling. This is especially important for permanent
press, knits and synthetic fabrics.

Cycle and temperature tips

Use a High heat setting for drying heavyweight items such as
towels, work clothes and sheets.

Use a Low heat setting for drying lightweight items such as
lingerie, underwear, blouses, dresses, permanent press
fabrics and some knits.

Use a no-heat (air) setting for rubber, plastic or heat-sensitive
fabrics.

Line dry bonded or laminated fabrics.

NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions. If you are unsure
of the temperature to select for a load, select a lower setting
rather than a higher setting.

Dryer Symbols

The control panel of your dryer contains symbols. Refer to the
chart below for a definition of those symbols.

Cycle Descriptions

This manual covers several different models. Your dryer may vary
from the model shown and may not have all of the cycles and
features described.

Cycle Control knob

Auto Dry cycle

Use your Automatic cycle to dry most loads. Your dryer has a
control that senses the moisture level in the load and shuts off
when the load reaches the selected dryness.

Symbols

Symbols

Cool Down

Low/Knits

TUMBLE PRESS

Cycle

Medium/
Permanent Press

Damp Dry

High/Heavy

Wrinkle Shield

Temperature

Timed Drying

On

Delicates

Off

Quick Dry

Push to Start

Synthetics/
Permanent Press

Push to Start

Cotton

Air Fluff

Heavy

Read Operators
Manual

This manual is related to the following products: