Western Telematic IPS-400 User Manual

Page 21

5-5

Conﬁ guration

5.3. Configuration Menus

As described in the sections that follow, conﬁguration parameters for

the IPS can be selected via the Web Browser Interface or Text Interface.

Although the Web Browser and Text Interface provide two separate means

for selecting parameters, both interfaces allow access to essentially the

same set of parameters, and parameters selected via one interface will also

be applied to the other.

Note:

Conﬁguration menus are only available when the System

Mode is active. Conﬁguration menus are not available if you have

logged in using a Plug Password.

Web Browser Interface: Click the "Setup" button to gain access to the

conﬁguration menus; a row of buttons will be displayed along the left hand

edge of the screen. Click the appropriate button to access the desired menu.

Note the following:

• Newly selected parameters will not be activated until you click the

"Apply" button.

• Click "Switch Panel" to return to the main status screen.

Text Interface: Refer to the Help Screen (/H), then enter the appropriate

command to access the desired menu. When the conﬁguration menu

appears, key in the number or letter for the parameter that you wish to

deﬁne and follow the instructions in the resulting submenu. Note the

following:

• To exit from a parameters menu, press the [Esc] key.

The following sections describe options and parameters that can be

accessed via each of the conﬁguration menus. Please note that essentially

the same selection of parameters and options are available via both the Web

Browser Interface and Text Interface.