Wren Associates DRS5016 - Manual (Page 18)

Installation and Connection DRS5116
Wren
2003. 09. 06 (v 1.0) 18
Installation and Connection
4. Connecting & Running
4.1. Connecting Camera
(1) Connect the CCTV camera to the DRS with the BNC cable as shown below.
1. The video type for all channels should be either NTSC or PAL.
2. The DRS sets video signal’s impedance (75Ω) automatically. Impedance is set as 75Ω. When
connecting a device to video output, impedance will be “Hi-z” status.
3. Video type (NTSC/PAL) should be changed prior to installing the DRS Unit. To change the
video type, it is recommended to contact the closest local Wren distributor. When changing it,
refer to “Appendix #2. Changing Video Type”. Wren is not responsible for any service
warranty about a problem due to careless change.