Weslo WLTL62790 - Manual (Page 5)

5
the unit is in proper operating condition
(refer to the drawing below).
¥ Use No. 10 AWG (5.3mm 2 ) copper, No. 8
AWG (8.4mm 2 ) aluminum, No. 17 AWG
(1.0mm 2 ) copper-clad steel or bronze wire,
or larger as a ground wire.
¥ Secure antenna lead-in and ground wires to
house with stand-off insulators spaced
from 4 to 6 feet (1.22 to 1.83m) apart.
¥ Mount antenna discharge unit as close as
possible to where the lead-in enters the
house.
¥ Use jumper wire not smaller than No. 6
AWG (13.3mm 2 ) copper, or the equivalent
when a separate antenna-grounding elec-
trode is used. See NEC Section 810-21 (j).
Note to CATV system installer: This reminder is
provided to call the CATV system installerÕs at-
tention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particu-
lar, specifies that the cable ground shall be con-
nected to the grounding system of the building,
as close to the point of cable entry as practical.
Power Lines
Ground
Clamps Ground
Clamps
Ground
Clamp
Bonding
Jumper
Standoff
Insulators
Antenna
Lead-in Wire
Ground Wire
Ground
Wire
Antenna
Discharge Unit
To External Antenna
Terminal of Treadmill
Mast
Service
Entrance
Equipment
Power Service Grounding
Electrode System (e.g.
Interior Metal Water Pipe)
Service
Entrance
Conductors
Optional Antenna Grounding Electrode Driven 8
Feet (2.44m) Into The Earth (If Required By Local
Codes). See NEC Section 810Ð21 (f).
SAVE THESE INSTRUCTIONS
The decal shown below has been placed on your treadmill in
the indicated location. If the decal is missing or illegible,
please call our Customer Service Department, toll-free, at
1-800-999-3756 to order a free replacement decal. Apply the
decal in the location shown.
Note: The decal is shown at 38% of actual size.