weber Platinum C - Manual (Page 14)

B-3
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(10)
(9)
Check that the side burner is properly assembled.
1) Windshield
2) Grate
3) Burner cap
4) Burner ring
5) Lugs
6) Slots
7) Igniter electrode
8) Burner head
9) Burner base
10) Burner orifice
ƽWARNING: Set the side burner ring onto the side
burner head. Rotate the burner ring until the four lugs
on the burner ring are seated in the four slots on the
burner head.
Install Side Burner Assembly
You will need side burner assembly (assembly includes
mounting frame), two 1/2 inch bolts, two nylon washers and
a 7/16 inch or adjustable wrench.
Note: Remove protective covers from tabs of side burner
Insert the side burner tabs in the slots of the frame(1). Slip
washers on the bolts and insert the bolts as shown(2).
Tighten bolts with wrench.
(1) (2)
Note: The burner head has a hole in it that fits over the
igniter electrode.
Connect side burner to manifold
ƽ WARNING: Make sure gas supply is off.
Connect the side burner hose as follows:
1) Slide back the collar of the quick disconnect on the
manifold.
2) Push the male fitting of the side burner hose into the
quick disconnect, and maintain pressure. Slide the
collar closed.
Quick disconnect will be engaged.
Check to be sure the side burner valve is OFF. Push the
side burner control knob down and turn it clockwise. If it
doesn’t turn, the valve is OFF. If it does turn, continue
turning it clockwise until it stops, then the burner valve is
OFF.
(1)
(2)