Wrangler JEEP P5063 - Manual (Page 13)

P5063pr-0923
13
ASSEMBLY F
• Fit the spacers between the upper holes of the brush guard
and the front end of the vehicle A .
• Insert two #8 x 4" screws through the two upper holes in the
brush guard, through the spacers and into the front end of the
vehicle
B . Tighten the screws.
Spacers
#8 x 4" Screws
16
A
B
Locked Unlocked
Lock
Fastener
Lock
Fastener
• Using a slotted screwdriver, turn each lock fastener in the hood
1 /
4
turn to the locked position.
IMPORTANT! Remember to keep the lock fasteners locked at
all times to prevent children from accessing the vehicle
battery compartment.
Brush Guard 15
14
• Fit the brush guard to the front end of the vehicle.
Hint: Using the end of a Phillips screwdriver, poke a hole in the
thin plastic covering over the lower holes in the brush guard.
• Insert two #10 x 1" screws through the lower holes in the
brush guard and into the front end of the vehicle. Tighten
the screws.
P5063a-0920